The Microsoft Windows configuration consists of a set of default programs provided with Windows, as shown in the following screen shot. Three possible configuration options are presented to the user, with the option for OEMs to present a fourth option titled "Computer Manufacturer". The Windows 8 Set Program Access and Computer Defaults page is shown in the following screen shot. This tool is used for the following five client types.Īn Overview of Set Program Access and Computer Defaults Provides a set of preset default program choices.Enables control of the display of the program's icons, shortcuts, and menu entries.Enables the choice of default programs for each client type (up to Windows 7 only).For registered programs, it performs the following functions: In Windows Vista and later, it is located under the Default Programs Control Panel item. In Windows XP, Set Program Access and Defaults is a tool found as an option in Control Panel's Add or Remove Programs item. It's possible that the per-machine defaults were never seen by users in Windows Vista and Windows 7 if they had previously set per-user defaults, because per-user defaults override per-computer defaults in those operating systems. When a per-user default has not yet been configured by the user, the system will prompt them to set a per-user default rather than falling back on a per-machine default. Prior to Windows 8, SPAD set per-computer defaults. Disabling the local Administrator account does not prevent you from logging on to the recovery console as Administrator.As of Windows 8, SPAD configures defaults on a per-user basis for the current user. You can use the recovery console to access the computer even if the local Administrator account is disabled. Log on to Windows by using Recovery Console Start your computer to Safe mode with networking support.Ĭlick Start, click Run, type cmd, and then press Enter.Īt the command prompt, type the following command, and then press Enter: net user administrator /active:yes To enable the Administrator account, follow these steps: If the server is a domain controller, the Local Users and Groups are not available in Computer Management. Click to clear the Account is disabled check box, and then click OK.Expand Local Users and Groups, click Users, right-click Administrator in the right pane, and then click Properties.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |